Filter
Top Products
5.1.5 +15 VDC Power Jack
This connector provides the DC power required to operate the pan and tilt head. The connector
type is a Switchcraft 722 series. The outer conductor is for 15 VDC, the center conductor is
ground from the power source. The pan and tilt head requires a power supply capable of a
minimum of .8 amps at 15 DC. The power connection to the pan and tilt head is made via a 5.5
mm X 2.10 mm female DC plug located on the power supply. Caution: the center pin of this jack
is ground. The DC voltage is applied via the outer ring of the DC plug.
5.1.6 VIDEO
The BNC type video connector provides a convenient means to connect the users equipment to
the pan and tilt head. The video source originates at the camera’s system video connector
(“VIDEO OUT”). This video is routed to the trunnion (rotating section of head) of the pan and
tilt via a 18 inch seventy five ohm video connector. The video is routed to the base of the head
using the pan and tilt’s cable wrap technique, which is internal to the rotating mechanism of the
pan and tilt.
5.2 PAN & TILT TRUNNION CONNECTORS
5.2.1 Video in
This BNC type video connector located on the trunnion provides a means to connect the users
camera to the pan and tilt head. Note that this connector is not labeled. The video source
originates at the camera’s video connector (“VIDEO OUT”). This video is routed to the trunnion
of the pan and tilt via a short 18 inch video cable and this connector. The video is routed to the
base of the head using the pan and tilt’s cable wrap technique which is internal to the rotating
mechanism of the pan and tilt.
5.2.2 DIN, 8 pin Circular
This connector which is located on the trunnion adjacent to the video BNC connector provides a
means to connect the camera lens control signals from the pan and tilt head to the camera/lens
assembly. The output pin assignments for this connector are jumper selectable from within the
pan and tilt base. The figure below illustrates the pin lay out for the eight pin circular DIN
connector. Note that this connector is not labeled
Mating Connector
View
6
7
3
8
5
4
2
1
7
6
1
8
4
5
2
3
Wiring Side
View
8 Pin DIN
Connector
2/12/05 Document D0153
16