Filter
Top Products
3.3.2 Pan & Tilt Limit Adjustment
The pan & tilt head has separate adjustments for limiting pan-left, pan-right, tilt-up and tilt-
down. The adjustment of these limits are described below.
NOTE: These adjustments are to be made after the controller has been interfaced to the DPT
115. The controller will allow one to move the pan & tilt head and check the pan & tilt limits.
Pan Adjustment
View A illustrates the location of the pan limit
adjustments on the trunnion. To adjust the limit of pan
travel, loosen the “Right Pan Limit Adjustment” screw
and rotate the pan-right limit block to the desired
position. Loosen the “Pan-Left Limit Adjustment screw
and rotate the pan-left limit block to the desired
position.
With the controller power “ON”, move the joystick in the
pan position. Check the pan-right travel and the pan-left
travel. If either limit is still not adjusted properly, repeat
the adjustments described above.
NOTE: The pan limit switch adjustments are set at their
maximum travel by ESI.
Video Output
Video from
Camera
Pan Limit
Switch
Adjustment
VIEW A
Camera
Mounting
Adjustment
Tilt Vertical
Position Keys
2/12/05 Document D0153
8