Filter
Top Products
48
SETTING AND ADJUSTMENTS BEFORE SHOOTING
Audio Input Signal Selection
The GY-HD110 is provided with the INPUT1 connector and
the INPUT2 connector for audio input.
Select the audio from the INPUT1 connector or the INPUT2
connector using the CH-2 INPUT switch for the audio to be
recorded in CH-2.
Selecting the CH-2 channel input con-
nector
Select using the CH-2 INPUT switch.
MEMO
The audio from the INPUT1 connector is also input into CH-
1 regardless of the setting.
Selecting the audio signal input
Select the sound to be input to the INPUT1 or INPUT2 con-
nector using the AUDIO INPUT switch.
The setting is made for each of INPUT1 or INPUT2 connec-
tor.
CAUTION
When connecting a component that does not require +48 V
power supply, make sure that the switch is not set to
MIC+48V before the component is connected.
MEMO
You can select the normal input level for MIC and MIC+48V
in the INPUT1, 2 MIC REF. item on the AUDIO/MIC [1/2]
menu screen.
Adjusting Audio during Recording
For each audio channel, use the CH-1/CH-2 AUDIO SELECT
switch to select whether the audio level adjustment should be
set to AUTO mode or MANUAL mode.
Adjusting the audio input level control
The audio input level can be adjusted manually when the GY-
HD110 is in the record, record-standby or stop mode.
1. Set the CH-1/CH-2 AUDIO SELECT switch of the channel
whose audio level that you want to adjust manually to
MANUAL.
2. Rotate the audio input level control corresponding to the
audio input level to be adjusted.
• Adjust so that the peak level does not exceed the –3 dB
point when a loud sound is input.
CH-2 INPUT switch
AUDIO INPUT
switch
MONITOR SELECT
switch
FULL AUTO switch
Monitor
speaker
MONITOR
volume
CH-1 audio input
level volume
CH-2 audio input level
volume
CH-1/CH-2
AUDIO SELECT switch
STATUS 1 screen
Audio level
Indicator level (reference)
INPUT1 : Inputs the audio from the INPUT1 connector
into CH-2.
INPUT2 : Inputs the audio from the INPUT2 connector
into CH-2.
LINE : Set to this position when connected to audio
equipment, etc.
The reference input level is +4 dBs.
MIC : Set to this position when using a dynamic micro-
phone.
MIC+48V : Set to this position when a microphone (phan-
tom microphone) requiring +48 V DC power sup-
ply is connected.