Filter
Top Products
21
Write-Protect Switch on the SDHC/SDXC
Card
A Slide the write-protect switch upward to enable writing or
deleting.
B Slide the write-protect switch downward to prevent writing
or deleting. (Data in the card are protected.)
ⅥCard Slot Status Indicator
The following table shows the respective states of slot A and B.
Formatting (Initializing) SDHC/SDXC Cards
When the following cards are inserted,
A
FORMATTING
REQUIRED
B
appears. Format the card using the camera
recorder menu.
●
Unformatted SDHC/SDXC cards
●
SDHC/SDXC cards formatted under different specifications
Note :
●
Be sure to format the SDHC/SDXC card on this camera
recorder. SDHC/SDXC cards formatted on a PC and other
peripheral equipment cannot be used on this camera
recorder.
Memo :
● To cancel the message display, press the center of the set
lever.
● A [!] mark and the message AFORMATB appear at the
remaining media area when an SDHC/SDXC card that
requires formatting is inserted.
1
Select [Format Media] in the [Media] menu. (
A
Page 75)
2 Select the slot of the SDHC/SDXC card to be
formatted and press the center of the set lever.
3 The status of the selected SDHC/SDXC card appears.
4 Select [Format] and press the center of the set lever.
5 Formatting starts.
6 Formatting is complete.
ACompleteB appears when formatting is complete.
Memo :
●
If you do not want to format the card, select [Cancel] and
press the center of the set lever to return to the previous
screen.
●
If you remove the SDHC/SDXC card during formatting,
A
Format Error!
B
appears and the camera recorder returns to
the previous screen.
●
During formatting, menu operation is unavailable but you can
start recording. However, this is only available when a
recordable SDHC/SDXC card is inserted in the other slot.
●
Formatting cannot be performed in the following cases.
• Recording is in progress on the SDHC/SDXC card to be
formatted.
• SDHC/SDXC card is not inserted.
• Write-protect switch of the SDHC/SDXC card is set
( is displayed).
Note :
●
If you format the SDHC/SDXC card, all data recorded on the
card, including video data and setup files, will be deleted.
Lamp Slot Status
Blinks in green Inserted SDHC/SDXC card is being accessed.
(writing/reading data)
Do not turn off the power of the camera
recorder or remove the SDHC/SDXC card.
Lights up in green On standby. Inserted SDHC/SDXC card can
be used for recording or playback.
Light goes out ● SDHC/SDXC card is not inserted.
● An unusable card is inserted.
● An SDHC/SDXC card is inserted but a
different slot is selected.
AB
Write/Delete Enabled Write/Delete Disabled
Write-Protect Switch
2
4
GY-HM150U.book Page 21 Monday, September 5, 2011 1:48 AM