Filter
Top Products
24
Setup
Electricity can be supplied to this product either
by using the PoE or connecting to the DC 12 V
power supply.
ⅷ When electricity is supplied to the camera,
the status indicator blinks, and turns off when
startup is complete.
Note：
● Make sure to select only one mode of
electrical supply. Connecting the power cable
and the LAN cable for the PoE at the same
time may result in failure or malfunction of the
camera.
Using the PoE
Connect to a device that supports PoE and
supply electricity from the LAN cable.
Memo：
● For details on the connection method and
cable type, please refer to ALAN Cable
ConnectionB (A Pg. 26).
Connecting to the DC12 V power supply
Connect this product to the DC12 V power
supply when not using the PoE.
Connect the polarity correctly.
Red : DC12 V+
Black : DC12 V-
Note：
● Make sure to select only one mode of
electrical supply. Connecting the power cable
and the LAN cable for the PoE at the same
time may result in failure or malfunction of the
camera.
Memo：
About the power cable
● When using 2-core VVF (Vinyl-insulated
vinyl-sheath cable), the connection distance
is as follows: (Reference value)
Power Connection
What is PoE (Power over Ethernet)?
This is a function that enables operation of a
LAN equipment without a power cable by
supplying power simultaneously with the data
using a LAN cable.
Connect to PoE-
compatible device
LAN cable
10BASE-T/
100BASE-
TX(PoE)
terminal
Maximum
extension
90 m
(300 ft)
240 m
(790 ft)
390 m
(1280 ft)
Conductor
Diameter
(mm)
R
1.0 and
above
R
1.6 and
above
R
2.0 and
above
Power cable
Red:
DC12 V+
Black:
DC12 V-
Solder or
crimp
Insulation tape
Wind the
waterproof
tape
LAN cable
Base
Heater power cable
(White, Gray)
VN-C215VP_EN.book Page 24 Wednesday, December 20, 2006 4:26 PM