Filter
Top Products
B-3
Appendix B
Other symptoms, causes and remedies
Symptom Cause Remedy
The camera settings cannot be
changed.
The camera is turned Off. Turn on the camera.
Autofocusing does not operate. The Focus Mode selector is set to
M.
Set the Focus Mode selector to C
or S.
The shutter does not release. The camera is busy writing to the
PC Card.
Wait until the PC Card icon on the
Back Status LCD panel stops
blinking.
The subject is not in focus. Wait until the subject is in focus.
No room on PC Card. Replace the PC Card or delete
some images.
No PC Card in camera. Insert a PC Card.
The Frames Remaining indicator
on the Back Status LCD panel
reads 0.
The PC Card is full. Insert a different PC Card or delete
some images from the PC Card.
The battery icon on the Back
Status LCD panel shows that the
battery is low.
Battery is low. Recharge the battery, replace it
with a freshly charged battery, or
connect the AC adapter or the Auto
DC adapter.
Exposed a burst of images and the
Card icon continues to flash.
It takes time to save a burst of
images.
Wait a few seconds.
The camera is “locked.” Nothing
works.
The battery is not securely in place. Remove then insert the battery.
The camera turned Off. This can be caused by static
electricity or a poorly loaded
battery.
Turn the camera off then on, or
remove the battery and install it
again.
You just inserted a new battery and
the camera is “locked.”
You didn’t turn the camera Off
before changing batteries.
Turn the camera off. Remove the
new battery. Wait 10 seconds,
insert the same battery, then turn
the camera On.
The Depth-of-Field Preview button
does not work properly.
No PC Card is inserted. Insert a PC Card.