Kyocera NX Digital Camera User Manual


 
89
Set the position dial to “CF”.
The display panel is as shown at left
(custom function setting mode).
Turn the R dial to select
“Function number”.
Turn the F dial to select “Detail
number”.
Set the position dial to a position
other than “CF”.
The custom function is set.
Return the dial to “ ” (white) or “
(green) and take the photograph.
The display panel returns to the normal
display.
To initialize all set functions, display
“CLE” as previously described in 2,
and set to a position other than “CF”.
88
2. Setting custom functions
Detail number
Function number
Detail number
Detail
Display panel
Function num-
ber
Custom function setting mode
Standard set-
ting (0)
Changed set-
ting (1)
Changed set-
ting (2)
Changed set-
ting (3)
Detail number
Function number
Superimpose
when focused
On Off
Rewind auto return
Auto return on Auto return off
Leave film tip
when rewinding
Film tip not left Film tip left
Selection of aper-
ture stop-down
button operation
Aperture
stopped down
while pressed
Aperture switches
between stopped
down and open
each time button
is pressed
Focus button
function in “MF”
mode
SAF CAF
Red-eye reduc-
tion with internal
flash
Off On
Exposure com-
pensation setting
(with Av, P)
F dial
F dial and
R dial
Exposure value
display when zoom
lens is fitted (*)
Align aperture
ring
Link to zooming
Continued exposure
compensation
Until power
supply OFF
Until setting
cancelled
Exposure com-
pensation setting
F dial
Set with F dial
while pressing
LIGHT button
CLE: Resetting cus-
tom functions
The custom functions ( ~ ) are always set to the standard settings.
Note that if the exposure mode selector lever is set to any posi-
tion other than “CF” at this time, all the custom functions are
reset to the standard settings (i.e. to “0”).
* When using lenses for which the open aperture value (brightness) with zooming varies
(eg. Vario Sonnar 28-80mm F3.5-5.6), the actual aperture is controlled by the camera so
that it assumes the value set with the aperture ring, rather than being controlled by zoom-
ing. Set Custom Function to (1) to vary the aperture with zooming.
11-1BC(E)_P086-89 11/15/01 7:29 PM Page 88