Filter
Top Products
Miscellaneous
Q&A Troubleshooting
- 211 -
Monitor
No picture is displayed on the monitor.
●
[Opt. Viewfinder] is set to [ON].
→ Press the [DISP] button to switch to monitor display.
●
The display of an attached external viewfinder is selected.
→ Press the [EVF/LCD] button of the viewfinder to switch to monitor display.
The brightness varies.
●
The aperture is set while shutter button is pressed halfway. (This does not affect the recorded
picture.)
This symptom may also occur when the brightness changes due to zooming or because the camera
is moved. This is the automatic aperture operation of the camera and is not a malfunction.
The monitor image flickers indoors.
●
The monitor image may flicker for a few seconds after turning on. This is an operation to correct
flicker caused fluorescent or LED lights etc. and is not a malfunction.
The monitor image is too bright/too dark.
●
[LCD Mode] is activated. (→31)
●
Use [LCD Display] to adjust the brightness of the monitor. (→31)
Black/blue/red/green dots or interference appears. The monitor image looks distorted
when touched.
●
This is not a fault, and will not be recorded on the actual pictures.
Even when I press the [EVF/LCD] button of an attached external electronic viewfinder
(available as accessory (→8)), the display does not switch between the monitor and
viewfinder.
●
When it is connected to a computer or a printer, the camera can only display pictures on the monitor.