Filter
Top Products
Miscellaneous
Usage cautions and notes
- 218 -
Charging the battery
●
The time required for charging varies depending on the conditions of battery usage.
Charging takes longer at high or low temperatures and when the battery has not been
used for some time.
●
The battery will get warm during charging and for some time thereafter.
●
The battery will be drained completely if not used for long periods of time, even after
being charged.
●
Do not leave any metal items (such as clips) near the battery’s terminals or a connected
charger’s plug.
Otherwise, a fire and/or electric shocks may be caused by short-circuiting or the
resulting heat generated.
●
Frequently charging the battery is not recommended.
(This would reduce its maximum usage time and can cause it to expand.)
●
If the achievable battery capacity is significantly reduced, it is reaching the end of its
lifespan. Please purchase a new battery.
●
When charging:
• Wipe dirt from the battery terminals with a dry cloth.
• Keep at least 1m (3’ 3”) away from an AM radio (this may cause radio interference).
●
Do not use a damaged or dented battery (especially with respect to its terminals), e.g.
by dropping (can cause faults).
Charger
●
Depending on the environment while charging, the charging LED may flicker due to
static electricity or electromagnetic fields, etc. This has no effect on charging.
●
Keep at least 1m (3’ 3”) away from an AM radio (this may cause radio interference).
●
The charger may generate whirring sounds when it is being used. This is not a
malfunction.
●
After use, be sure to disconnect the charger from the electrical outlet. (A very small
amount of current is consumed if it is left connected.)
Lens
●
Images may appear slightly white if the lens surface is dirty (fingerprints, etc.). Turn
the power on, hold the extended lens barrel with your fingers, and gently wipe the lens
surface with a soft, dry cloth.
●
Do not leave the lens exposed to direct sunlight.
When using a tripod or unipod
●
Do not apply excessive force or use damaged screws. (This may damage the camera,
its tripod thread, or its label.)
●
Ensure that the tripod is stable. (Refer to the tripod instructions.)
●
You may not be able to remove the card or the battery when using a tripod or unipod.