Filter
Top Products
Problems with the remote controller mode and flash
bracketing:
• A flash bracketing sequence is not possible in remote
controller mode! If flash bracketing has been set and
the mecablitz is then set for remote mode, flash
bracketing will no longer be displayed, nor is it carried
out!
Remote controller mode with flash exposure correc-
tion:
• If flash exposure correction is set on the mecablitz,fol-
lowed by a change to remote controller mode, then the
subsequent shots will be exposed with this correction
value, but the mecablitz display will not (!) indicate the
correction value!
(Ni): No Nikon underexposure display in remote
mode:
• Some Nikon cameras indicate a warning signal (-EV)
on the LC display of the mecablitz if a shot is underex-
posed by flash.The mecablitz does not support this
function in remote mode.
No REAR mode with HSS high-speed synchronisati-
on:
• REAR mode (second-curtain synchronisation) cannot
be set when HSS high-speed synchronisation has been
activated on the mecablitz.
• Setting HSS high-speed synchronisation when REAR
mode is set deactivates the REAR mode!
The ISO film speed is not indicated on the display of
the mecablitz
• The mecablitz is either in remote mode ("Co" or "SL")
or in stroboscope mode.The ISO value is never indica-
ted on the LC display of the mecablitz when these ope-
rating modes have been set.
• The Canon and Minolta system cameras do not indica-
te the ISO value on the LC display!
Nikon 3D flashlight pulses cause uncontrolled slave
operation
WARNING:The mecablitz slave is triggered in an
uncontrolled manner when the sensor in the SCA
3082 slave adapter receives the light from a flash
unit operating in Nikon 3D mode!
• This can only be remedied by changing from 3D mode
to normal TTL flash mode (without 3D).
☞
Troubleshooting hints
Cosa fare in caso di anomalie
En caso de problemas
110
700 47 0078-A4 PDF GB-I-E 30.09.2008 14:12 Uhr Seite 110