Filter
Top Products
Overview Using Camera Control Pro
Return to fi rst page
94
Appendices
Camera Control Pro 2
Registering the Device Driver
Follow the instructions below to check that the camera has been correctly regis-
tered with the system.
Device Registration Windows XP 2/4
1
Open the Device Manager
Open the Device Manager and confi rm that “Nikon 1394 Protocol Device”
and the camera is listed.
If the camera is listed under “Other devices,”
reinstall the device drivers
reinstall the device drivers.
If “Nikon 1394 Protocol Device” is not listed in the Device Manager and the
camera does not appear under “Other devices,” disconnect the camera and
restart the computer.
Reconnect the camera after the computer has restart-
ed.
2
Double-click the listing for the camera that appears under “Other devices.”
Click the “General” tab and confi rm that “This device is working properly” ap-
pears under “Device status.”
Troubleshooting
If “1394 Bus host Controller” is listed in the Device Manager but the entry for the Nikon D1 (D1X/D1H)
does not appear, check the following:
• Is the camera on?
• Is the battery fully charged? If you are using an AC adapter (available separately), is it properly
connected?
• Is the mode dial set to “PC”?
• Is the IEEE 1394 cable properly connected?