Nikon 26494 Digital Camera User Manual


 
xiv
Introduction
Notes About Operating Temperature and
Humidity and Condensation
The operation of this camera has been tested at temperatures from −10°C to
+40°C (14°F to 104°F).
When you use the camera in cold climate regions or at high altitudes, observe
the following precautions.
The performance of the batteries (number of images shot and shooting
time) will drop temporarily. Keep the camera and batteries warm inside a
cold-resistant container or under your clothing before use.
If the camera is in a very cold state, the performance may drop temporarily,
for example, the monitor may be darker than normal immediately after the
camera is turned on or residual images may be produced.
When snow or water droplets adhere to the exterior of the camera,
immediately wipe them off.
- If the buttons or switches are frozen, they may not operate smoothly.
- If the microphone or speaker openings are clogged with water droplets,
the sound may deteriorate or become distorted.
Operating environmental conditions such as
temperature and humidity may cause fogging
(condensation) on the inside of the monitor or lens.
This is not the camera malfunction or defect.
Environmental conditions that are likely to
cause condensation inside of the camera
Fogging (condensation) may occur on the inside of the monitor or lens in the
following environmental conditions where there are sharp temperature changes or
high humidity.
The camera is suddenly immersed in low temperature water after being in a
high temperature place on land, such as on the beach or in direct sunlight.
The camera is brought to a warm place such as inside a building from the
cold climate outside.
The battery-chamber/memory card slot cover is opened or closed in a high-
humidity environment.
Clearing the fogging
Open the battery-chamber/memory card slot cover after turning off the
camera in a place where the ambient temperature is stable (avoid any place
that has high-temperature/high-humidity, sand or dust).
To clear the fogging, remove the battery and memory card, and leave the
camera with the battery-chamber/memory card slot cover open to allow
the camera to adjust to the ambient temperature.
If the fogging does not clear, consult your retailer or Nikon-authorized
service representative.