Filter
Top Products
188
Chapter 12
Troubleshooting
1 The power is off.
2 The batteries are
loaded incorrectly.
3 The batteries are
exhausted.
4 The batteries are
temporarily unable to
function.
5 It is connected to a
personal computer.
6 The camera is in the
sleep mode.
1 Set the mode dial to any
position except OFF to turn
on the camera.
2 Reload the batteries
correctly.
3 Replace the batteries with
new ones
.
4 The batteries may be too
cold. Keep them warm while
using the camera.
5 The camera will not operate
while it is connected to a
personal computer.
6 Operate the camera (press
the shutter button, turn the
mode dial, etc.)
P. 30
P. 25
P. 25
—
P. 175
P. 30
POSSIBLE CAUSES CORRECTIVE ACTION
REF. PAGE
The camera does not work or function buttons do not respond.
No picture is taken when the shutter button is pressed.
1 The mode dial is set to
.
2 The memory gauge is
full.
3 The flash has not
finished charging.
4 The card access lamp
blinks after shooting in
the Movie mode.
5 There is a problem with
the card.
6 The card is full.
1 Set the mode dial to any
position except .
2 Wait until there is room in
the memory gauge.
3 Release your finger from the
shutter button. When the
orange lamp stops blinking,
try to shoot again.
4 The recorded movie image
data is being written to the
SmartMedia card. You can
start shooting again when
the card access lamp stops
blinking.
5 See the error code chart.
6 Replace the card or delete
unwanted pictures, etc.
P. 64
P. 83
P. 92
P. 85
P. 196
P. 29, 141,
142