Filter
Top Products
33
Power on/off
1
Getting started
If the card is not recognized (card check)
When the power is turned on, the camera checks the card automatically. If
there is no card in the camera or a card that is not supported by this camera
is inserted, the following screen is displayed.
• All data stored on the card is erased when the card is formatted.
Control panel
Monitor
indication
Corrective action
NO CARD
There is no card in the camera or
the card is not inserted properly.
→ Insert a card. If a card is already
inserted, remove it and insert it
again correctly.
CARD ERROR
There is a problem with the card.
→ Use a different card. Insert a
new card.
The card cannot record, play back
or erase pictures.
Format the card or replace it with a
new one.
→ Press to select POWER
OFF, then press . Replace it
with a new one.
→ Format the card.
Press to select
FORMAT, then press to
display the confirmation screen.
Select YES and press .
Formatting starts. If the card
was successfully formatted, the
camera is ready to take
pictures.
Note
- - -
- E-
- F -
POWER%OFF
FORMAt
CARD%SEtUP
SELECt
GO