Filter
Top Products
– 59 –
Selecting the audio input
To connect phantom microphones or the line input to the audio input connectors on the rear
panel, set the internal switches (audio input selector switches) to the appropriate positions.
Audio input selector switches
1
2
3
4
5
6
1
2
3
4
5
6
1
2
3
4
5
6
When an ordinary microphone is used (factory settings):
ON
OFF
1
2
3
4
5
6
1
2
3
4
5
6
ON
OFF
CH1 selector
switches
SW4101
CH2 selector
switches
SW4201
ON : 3, 5
OFF : 1, 2, 4, 6
When a phantom microphone is to be used:
Set the switches to the above positions.
ON
OFF
ON : 3, 5, 6
OFF : 1, 2, 4
When the line input is to be used:
Set the switches to the above positions.
The line input level can be switched to one of three settings: –6 dB, 0dB or +4 dB.
It is set using the REAR CH1 MIC/REAR CH2 MIC menu item (on the AUDIO
menu/see page 51) but the menu screen display will remain unchanged even when the
internal switches are set to the positions shown above. Use the table given below as a
reference to convert the input level.
ON
OFF
ON : 1, 2, 4
OFF : 3, 5, 6
Technical details:
1: For selecting the gain
(gain is increased at OFF).
6: For selecting the phantom
power supply.
2, 3, 4, 5:
For selecting the attenuator.
Menu display For microphone For line input
–60 dB
–50 dB
–40 dB
–60 dB
–50 dB
–40 dB
–6 dB
0 dB
+4 dB