Filter
Top Products
24 (E)
Power supply
Using the BP-90 type battery pack
<Notes>
ODo not pull the rubber cap forcefully.
OWhen mounting the battery case, take care not to
pinch the connecting cord.
4
Attach the AU-M402H battery case.
Open the battery case cover, and raise it above the
rubber cap: screw holes will now be visible.
Tighten the screws using a screwdriver, then
attach the case to the NP/BP adapter plate and
tighten the screws fully.
5
Connect the plug on the battery pack to the
connector inside the case, and insert the battery
pack.
<Note>
Before connecting or disconnecting the plug, be
absolutely sure to turn off the unit’s power.
3
Connect these connectors with the connector on
the AU-MA402H battery case.
1
Attach the NP/BP adapter plate.
Insert it in the direction shown by the arrows, and
slide it into place.
2
Attach the connectors provided with the NP/BP
adapter plate to the positions shown in the figure.