Filter
Top Products
68 (E)
Tape management information
This unit automatically stores as the tape management information both the frame rate information which
indicates the shooting speed and the active frame information which indicates the first frame where the frame
image was switched in the user’s bit of the sub-code track area (this used to be the LTC area). This information
is output from the TC OUT connector and HD SDI OUT connector. Further, the active frame information is
stored in the least significant digit of the user’s bit while the frame rate information is stored in its lower third and
fourth digits.
Example of display
01:12:01:50
User’s bit setting
Frame frequency
5: 59.94 Hz
6: 60.00 Hz
Tape management information
OActive frame information
OREC START/STOP mark
01:12:01:xx
User’s bit setting
Tape management information
LTC user’s bit verification
information
To verify the VITC user’s bit, set the DISPLAY
switch to UB, and hold down the HOLD button.
While the HOLD button is held down, the VITC
user’s bit information appears on the counter
display.
02:40:24:50
OWhen the camera’s video signals are being
recorded
Recorded frame number count
This indicates the number of frames
recorded.
When the frame rate has been set to
24 fps and recording has been
performed for 10 seconds, “0240”
will be displayed as the count.
When recording is started, the count
is reset to “0000,” and the number of
recorded frames per cut is counted
up to “9999.”
Frame rate information
24 fps
(23.98 fps)
Frame frequency
5: 59.94 Hz
6: 60.00 Hz
Tape management information
OActive frame information
OREC START/STOP mark
VITC user’s bit
OWhen the internal colour bar signals are being
recorded
LTC user’s bit