Filter
Top Products
Advanced (Recording pictures)
51
VQT1B25
Taking Pictures using
Burst Mode
1 Press and hold the burst mode
button.
2 Press 3/4 to select a mode.
•You can also use the single or burst
mode button to select.
3 Press [MENU/SET].
•You can also press the shutter
button halfway or press the center of
the joystick to finish.
•The menu screen disappears after
about 5 seconds. At this time, the
selected item is automatically set.
4 Take a picture.
•Hold down the shutter button fully to
activate the burst mode.
∫ Number of pictures recorded in burst
mode
¢ The burst speed is constant regardless
of the transfer speed of the card.
•The number of pictures indicated is when
the shutter speed is faster than 1/60 and
the flash is not activated.
•The burst speed (pictures/second) may
become slower depending on the
recording environment such as in dark
places or if the ISO sensitivity is high.
•If you take pictures in burst mode with the
built-in memory, it will take time to write
the picture data.
•In simple mode [ ], the settings become
as follows. [ ] appears on the left of the
screen. (P120)
–[ ENLARGE]:
/Max. 5 pictures
–[ 4qk6q/10k15cm]/[ E-MAIL]:
/Max. 7 pictures
•When the flash is activated, you can
take only 1 picture.
•When the burst mode setting is set to
Unlimited
–The burst speed becomes slower
halfway. The exact timing of this
depends on the type of card, the picture
size and the quality.
–You can take pictures until the capacity
of the built-in memory or the card is full.
•The focus is fixed when the first picture is
taken.
BURST SHOOTING
SELECT SET
MENU
OFF
HIGH SPEED
LOW SPEED
UNLIMITED
or
Burst speed
(pictures/
second)
Number of recordable
pictures (pictures)
3
¢
max. 5 max. 7
2
¢
approx. 2
Depends on the
remaining capacity of the
built-in memory/card.
DMC-FZ8_PP ENG.book 51 ページ ２００６年１２月２６日 火曜日 午後４時２０分