Panasonic AG-HSC1UP Camcorder User Manual


 
28
VQT1F36
Setup
Setup
Charging the battery
When this unit is purchased, the battery is not
charged. Charge the battery before using this
unit.
Connect the battery to an AC adaptor to
recharge it.
The battery cannot be recharged by simply
inserting it into the unit.
If the DC cable is connected to the AC
adaptor, then the battery will not charge.
Remove the DC cable from the AC adaptor.
The Panasonic battery that can be used
with this unit is VW-VBG130. Other
Panasonic batteries will not work. (l 30)
1 Connect the AC cable to the AC
adaptor and the AC outlet.
Remove the DC cable beforehand.
2 Put the battery on the battery
mount by aligning the mark, and
then securely plug it in.
The output plug of the AC cable is not
completely connected to the AC adaptor
jack. As shown in A, there is a gap.
ª Charging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: Make sure that the terminals of the
battery or the AC adaptor are not
exposed to dirt, foreign objects or
dust, then reconnect them properly.
Disconnect the AC cable from the AC
outlet when you remove dirt, foreign
objects or dust on the terminals of the
battery or the AC adaptor.
If the charging lamp is still flashing,
something may be wrong with the
battery or AC adaptor. Contact your
dealer.
Battery charging time (l 30)
We recommend using Panasonic batteries
(VW-VBG130).
If you use other batteries, we cannot guarantee
the quality of this product.
A
VQT1F36_ENG_PP.book 28 ページ 2007年2月26日 月曜日 午前11時29分