Filter
Top Products
56
Chapter 4 Adjustments and Settings for Recording (continued)
4-10 Handling data
Setting Data Using an SD memory card
An SD memory card (optional accessory) can be used as a
setup card that stores up to eight files of settings menu
specifications.
This data allows you to quickly reproduce an optimum state.
Regarding SD memory cards, please see <Cautions in using
SD memory cards> (page 17).
4-10-1 Handling SD memory cards
An SD memory card may be inserted or removed, either
before or after the power is turned on.
To insert an SD memory card
Open the lid of the switch cover, and insert an SD memory
card (optional accessory) into the SD memory card slot with
the notch upward. Close the lid.
<Note>
An SD memory card must be inserted with the right side
facing the slot. If the card is hard to insert, it may be reversed
or upside down. Do not force it into the slot. Check the card
before re-inserting it.
To remove the SD memory card
Open the lid of the switch cover, and ensure that the BUSY
lamp is not illuminated. Then, further depress the SD
memory card towards the main unit. This releases the SD
memory card from the insertion slot. Take hold of the SD
memory card and remove it. Close the lid.
SD memory cards must not be used or stored in
an environment where they may be
z Exposed to high temperatures/humidities;
z Exposed to water droplets; or
z Electrically charged.
For storage, the SD memory card must be kept inserted into
the AJ-SPC700P with the lid closed.
4-10-2 Formatting, Writing and Reading
an SD memory card
To format an SD memory card, write settings data or read
data on an SD memory card, navigate the menu to the <SD
CARD READ/ WRITE> screen from the FILE page.
For an SD memory card formatted with a device that does
not support SD standards, the message “FORMAT ERROR”
appears at the upper right of the screen. In this case,
reformat the card as follows. Note that the indication
“FORMAT ERROR” does not disappear if the SD memory
card is replaced with this menu page open. When the SD
memory card is replaced, perform TITLE READ.
To format an SD memory card
<Note>
SD memory cards may be formatted via the thumbnail
screen. For more information, see [6-15 Formatting SD
memory cards].
1 Navigate the menu to the <SD CARD READ/WRITE>
screen.
2 Turn the JOG dial button to move the cursor to the
menu option CARD CONFIG.
3 Press the JOG dial button to display the following
message:
6'&$5'5($':5,7(!
56(/(&7
5($'
:6(/(&7
:5,7(
&$5'&21),*
7,7/(5($'
7,7/(
&21),*"
<(6
12
#,52%2'PINKUJDQQMࡍࠫ㧞㧜㧜㧢ᐕ㧡㧝㧝ᣣޓᧁᦐᣣޓඦ೨㧥ᤨ㧠㧡ಽ