Filter
Top Products
97
7
Chapter 7 Maintenance and Inspections (continued)
7-3-2 Error Codes
The following error codes are displayed in the display
window if an error occurs in the camera:
9. Battery Nearly Empty
Display window
indication
One of the bars in the battery remaining
indicator starts blinking.
WARNING lamp Blinks once per second.
Tally lamp Blinks once per second.
Viewfinder The BATT LED blinks.
Warning tone Beeps 4 times per second.
Warning
description
The battery is about to run out.
Recording/
playback operation
Continues to operate.
Countermeasures Replace the battery as required.
10. P2 Card Nearly Full
Display window
indication
One of the bars for remaining MEDIA
capacity starts blinking.
WARNING lamp
Blinks once per second while recording
continues.
Tally lamp
Blinks once per second while recording
continues.
Viewfinder
The P2 card remaining capacity indicator
blinks.
Warning tone
Beeps once per second while recording
continues.
Warning
description
The total remaining capacity of all the P2
cards is two minutes or less.
Recording/
playback operation
Continues to operate.
Countermeasures
Replace the cards. If there is an empty card
slot, insert a new card.
11. P2 Card Error
Display window
indication
If the error occurs during recording,
“00:0000:11” appears as the time code
indication. The indication continues to flash
after recording is stopped and until the next
operation is performed. There is no
indication if the error occurs during playback.
WARNING lamp
If the error occurs during recording, the lamp
flashes four times per second for a period of
about three seconds. The lamp does not
light if the error occurs during playback.
Tally lamp
If the error occurs during recording, the lamp
flashes four times per second for a period of
about three seconds. The lamp does not
light if the error occurs during playback.
Viewfinder
A flashing “CARD ERR _” appears. In the
actual indication the _ is replaced by the slot
number of the P2 card that triggered the
error.
Warning tone
If the error occurs during recording, the tone
sounds four times per second for a period of
about three seconds. The tone does not
sound if the error occurs during playback.
Warning
description
An error has occurred while recording data
to or playing data from a P2 card.
Recording/
playback operation
Stop recording or playback.
Countermeasures Replace the affected P2 card.
Code No. Description
E-11 Video initialisation error
E-27 Recording control error
E-30 P2 card removal error
E-38 P2 streaming microcontroller error
E-3F Microprocessor error in the camera control circuit.
E-6F Reference signal error.
#,52%2'PINKUJDQQMࡍࠫ㧞㧜㧜㧢ᐕ㧡㧝㧝ᣣޓᧁᦐᣣޓඦ೨㧥ᤨ㧠㧡ಽ