Filter
Top Products
66
Chapter 5 Preparation (continued)
Using an NP-1 type battery pack
1 Remove the battery holder.
2 Mount the NP-1 type battery case on the camera-
recorder.
Tighten the mounting screws.
Tighten the power contact screws.
Insert the upper part of the removed cover in the
direction of the arrow.
Align the holes in the bottom part (metal part) of the
cover with the holes in the case, and secure the
cover with the screw.
<Note>
When mounting the battery holder, take care not to
pinch the connection cord.
When using a V-mount type battery pack
Mount the V-mount adapter plate.
Insert the plate and slide it in the direction of the arrow.
3 Setting the battery type.
Select the battery type listed under BATTERY SELECT.
Select BATTERY SELECT from the <BATTERY/
P2CARD> screen on the MAIN OPERATION page.
When using a battery not listed under BATTERY
SELECT: If it is a NiCD battery, select “NiCd14(14V)”,
“NiCd13(13V)”, or “NiCd12(12V)”, depending on the
battery voltage. Set the other items according to the
battery properties. If it is not a NiCd battery, select
TYPE A or TYPE B and set the other items according to
the battery properties.
Please refer to [8-6-3 BATTERY SETTING2] for more
information.
<Note>
For information about the V-mount adapter plate,
please contact the store where you purchased the
camera-recorder.
CAUTION:
These servicing instructions are for use by qualified
service personnel only. To reduce the risk of fire or
electric shock do not perform any servicing other
than that contained in the operating instructions
unless you are qualified to do so.
Battery Case (for NP-1 type)
#,52%2'PINKUJDQQMࡍࠫ㧞㧜㧜㧢ᐕ㧡㧝㧝ᣣޓᧁᦐᣣޓඦ೨㧥ᤨ㧠㧡ಽ