Filter
Top Products
Operating Instructions
14
1.3 Camera Feature Locations
1.3.1 Front View
Indicator
Indicator can be controlled on Indicator Control window on page 90. Color
indications are shown below.
*
1
Orange indicator will continue blinking in the DHCP setting.
*
2
Refer to page 122 for the red blinking.
Lens and Pan/Tilt operation
Operation bar on the Single Camera screen can operate the Pan/Tilt. The Pan/Tilt
moves the lens horizontally from -175° to +175° and vertically from -120° to 0° in
mounting on the table and from 0° to +90° in mounting on the ceiling. Refer to
page 43 for the Pan/Tilt operation.
Notes
• When the power is on, do not manually revolve the Pan/Tilt. Revolving it
forcedly or moving it manually by some mistake may damage the Pan/Tilt
operation, or change the registered Pan/Tilt positions from actual ones.
Restart Network Camera when the latter case happens.
• Do not touch the lens. Touching it can remove the protective coating from the
lens. Fingerprints, dust, stains, etc. on the lens can also degrade the
performance of the Automatic Focusing feature.
Lens (Power Focus/Zoom Lens)
Wide: 5 mm (0.2 inches)—Infinity
Tele: 1 m (40 inches)—Infinity
(Refer to page 45.)
Indicator
(Refer to page 90 for the setup.)
Power
on
Normal Operation
Updating Firmware
Getting IP address
Finish getting IP address
Not on the LAN
Orange OrangeOrange blinking*
1
Orange blinking
Pushing FACTORY DEFAULT RESET button
Orange blinking twice
Internal Failure of Network Camera Red blinking*
2
On the LAN
Using
DHCP
Orange Green
Green
Green
Green blinking
Green blinking