Filter
Top Products
Operating Instructions
96
3.6.15 Reset to Factory Default
Reset to Factory Default window initializes all the parameters including the ID,
Password, IP address and Subnet Mask except Date and Time setting to the
factory default. Reconfirm the settings before doing the Reset to Factory Default
operation.
1. Click [Reset to Factory Default] on Setup Page.
2. Click [Execute].
• Indicator changes such as Orange blinking twice –> Turning off
about 15 seconds. Initializing takes about one minute.
•Click [Cancel] to quit. The window returns to Setup Page.
Notes
• Do not turn off the power during the Reset to Factory Default. It may
interrupt the Network Camera operation.
• IP address and Subnet Mask should be set again after Resetting to
Factory Default.
• FACTORY DEFAULT RESET button can also reset Network Camera
to the Factory Default. Refer to page 109.
• Internal clock will not be reset, however, time mode will return to AM/
PM mode and Auto adjustment will be disabled.
• If Reset to Factory Default is used, all user settings will be lost, and you
will have to reconfigure the entire Network Camera.