Filter
Top Products
Operating Instructions
[For assistance, please call: 1-800-272-7033] 93
3.6.14 Update Firmware
Update Firmware window allows the user to install the latest version of the
Network Camera internal operating system (Application and Camera firmware). In
most cases, this will never be necessary. Changes may be necessary to
accommodate new operating systems or new web browsers that are not shown
on page 10. In those cases, Update Firmware would be available from the
Network Camera Technical Support Site at http://panasonic.co.jp/pcc/en/.
Check the current firmware version on Setup Page on page 56.
Notes
• Do not turn off the power during Update Firmware. If the operation of
Update Firmware is stopped, refer to page 123.
• Buffered Images are erased when performing Update Firmware.
1. Download the proper firmware from the Network Camera Technical Support
Site mentioned above.
2. If Network Camera is accessible from the Internet, temporarily disable access
and connect Network Camera to the PC as the following figure. This will
eliminate any interruption during the Update Firmware.
Note
When Network Camera uses the DHCP function, change the Internet
connection from DHCP to Static in Network window. Refer to page 60 for
the network parameters.
3. Access Setup Page by entering "http://IP Address (or URL):Port No./
config.html" on the web browser and press [Enter].
• When port number is 80 (default), you do not need to enter port
number.
Ethernet hub
Without Ethernet hub, you should use category 5 cross cable.
Broadband Router
or
or
Category 5 straight cable