Filter
Top Products
13
Before Use
• Distance from the Camcorder: Within
approximately 15 feet (5 meters)
• Angle: Within approximately 15° in the vertical
and horizontal directions from the central axis
1 Direct the Remote Control at the Remote
Control Sensor
31
of the Camcorder and
press an appropriate button.
[VCR1]:
Press the [Ι►] Button and [■] Button
simultaneously.
1
[VCR2]:
Press the [◄Ι] Button and [■] Button
simultaneously.
2
• When the battery in the Remote Control is replaced,
the mode is automatically reset to [VCR1] Mode.
• The above operating ranges are for indoor use
Outdoors or under strong light, the Camcorder may
not operate properly even within the above ranges.
Selecting Remote Control Modes
When 2 Camcorders are used simultaneously, they
can be operated individually by selecting different
Remote Control Modes.
• If the Remote Control Mode of the Camcorder and
that of the Remote Control do not match, [CHECK
REMOTE MODE (REMOTE)] Indication is displayed.
Setup on the Camcorder
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Control Mode. (p. 19)
Setup on the Remote Control
15°
15°
15°
15°
12
31
Power Supply
Using the AC Adaptor
1 Connect the DC Cable to the Camcorder.
2 Connect the DC Cable to the AC Adaptor.
3 Connect the AC Cable to the AC Adaptor
and the AC Jack.
• Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch
42
on
the Camcorder to [OFF] and make sure that
[POWER] Lamp is not lit. (p. 16)
Using the Battery
• We recommend using a Panasonic Battery.
• We cannot guarantee the quality of this Camcorder
when batteries from other companies are used.
1 Attach the Battery to the AC Adaptor and
charge it.
• Since the Battery will not be charged when
the DC Cable is connected to the AC Adaptor,
disconnect it from the AC Adaptor.
• The [POWER] Lamp and [CHARGE] Lamp light
up, and charging starts.
• When the [CHARGE] Lamp goes off, charging is
completed.
• When the battery is completely discharged, the
[CHARGE] Lamp blinks at first, but the battery is
charged normally. When the temperature of the
battery is too high or low, the [CHARGE] Lamp
blinks and the charging time becomes longer
than usual.
Using the Remote Control (Optional)
Before use, fully charge the Battery.
Remote Control is not supplied, If you would like
to order, the parts number is LSSQ0411 as a
replacement parts. Please refer to page 68.