Filter
Top Products
14
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfo
Before Use
• For other notes concerning this item, see page 55.
Disconnecting the Power Source
Set the [OFF/ON] Switch
42
to [OFF], and while
sliding the [BATTERY RELEASE] Switch
46
,
remove the Battery downward or DC Cable.
• When attaching or removing Battery, set the
[OFF/ON] Switch to [OFF] and make sure the
[POWER] Lamp is not lit.
Charging Time and Available
Recording Time
CGR-D08R
A
1 h
B
2 h 10 min. (1 h 45 min.)
A
Charging Time
Maximum Continuous Recording Time
B
• “2 h 10 min.” indicates 2 hour and 10 minutes.
• Battery CGR-D08R is supplied.
• The times shown in the table are approximate
times. The numbers indicate the recording time
when the Viewfinder is used. The numbers in
parentheses indicate the recording time when
the LCD Monitor is used. In actual use, the
available recording time may be shorter.
• The times shown in the table are for continuous
recording at a temperature of 68 °F (25 °C) and
humidity of 60 %. If the Battery is charged at a
higher or lower temperature, the charging time
may be longer.
• The available recording time becomes shorter
if you use both of Viewfinder and LCD Monitor
simultaneously when rotating the LCD Monitor
forward to record yourself or setting [EVF ON/
AUTO] to [ON].
42
46
2 Attach the charged Battery to the
Camcorder.
• When not using the Lens Cap, pull the Lens Cap
Cord in the direction of the arrow.
1
• When you are not recording, be sure to cover the
Lens with the Lens Cap for protection.
2
Re-attaching the Lens Cap
To protect the Lens surface, attach the Lens Cap.
• The Lens Cap and Lens Cap Cord come
preattached to the Grip Belt.
1 Pass one end of the Lens Cap Cord through
the attached eye on the Lens Cap. Then
pass the Lens Cap through the loop made
by itself and pull tight.
To Use as a Grip Belt
Adjust the length of the Grip Belt to the size of your
hand.
1 Detach the end of the Grip Belt.
2 Adjust the length of the Grip Belt to the size
of your hand.
3 Reattach the Grip Belt.
2
1