Filter
Top Products
24
Recording Mode
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfo
By opening the LCD Monitor and rotating it forward
(to the lens side), you can let the subject in front of
the Camcorder monitor the shot while recording is in
progress.
• When the LCD Monitor is opened, the Viewfinder
is disabled automatically. However, when the LCD
Monitor is rotated forward, the image is also shown
in the Viewfinder.
• If you prefer to have the image on the LCD Monitor
to look like an image in a mirror, set [SELF REC]
on the [LCD/EVF] Sub-Menu to [MIRROR]. Images
are recorded normally and no left and right reversal
occurs.
Recording Yourself Quick Start
By pressing the [QUICK START] Button
40
, the
Camcorder will be ready for recording in approximately
1.3 seconds after it is turned on.
1 Press the [QUICK START] Button
40
.
• The Quick Start Recording Lamp
40
lights up.
2 Set the [OFF/ON] Switch
42
to [OFF].
• The Quick Start Recording Lamp remains lit.
3 Set the [OFF/ON] Switch
42
to [ON].
• The Camcorder will be ready for recording in
approximately 1.3 seconds.
• For other notes concerning this item, see page 56.
Self-timer Recording
When you set the self-timer, the recording starts
automatically after 10 seconds on the Card.
1 Set [TAPE RECORDING MENU] or [CARD
RECORDING MENU] >> [CAMERA] >>
[SELF TIMER] >> [ON].
• The [ ] Indication appears.
2 Press the [PHOTO SHOT] Button
35
.
• The [ ] Indication flashes and the recording
starts after 10 seconds.
• You can also use the RapidFire Consecutive
Photoshot. (p. 23)
• For other notes concerning this item, see page 56.
42
19
14 1513 16 17
35
40
To Cancel the Quick Start
Keep the [QUICK START] Button pressed for
approximately 2 seconds and make sure the Quick
Start Recording Lamp is not lit.
To brighten the natural colors in a scene. Gain Up
mode works with the Built-in Video Light to enhance
the light’s brightness.
1 Press the [LIGHT] Button
11
.
1
Recording with the Built-in LED
Video Light
• The Built-in LED Video Light lights and the Gain
Up mode is set to on.
• Gain Up mode will be brighter than when only
the Video Light is on, however, ghost images
will appear.
2 Press the [LIGHT] Button.
2
• Gain Up mode is set to off.
• To eliminate ghost images, use this mode.
3 Press the [LIGHT] Button.
3
• The Video Light turns off.
• Pressing the [LIGHT] Button again returns to
1
.
11
1 2 3
• For other notes concerning this item, see page 55.