Filter
Top Products
With a PC
49
To disconnect USB cable safely
For Windows
If USB Cable is disconnected while computer is
on, error dialog may appear. In such case click
[OK] and close the dialog box. By following the
steps below you can disconnect the cable safely.
1 Double click the icon in task tray.
• Hardware disconnect dialog appears.
Note on the driver name displayed
The driver name displayed will differ depending on
your OS, operating environment and the mode of the
Camcorder.
Windows XP/2000:
• When the Camcorder is in PC Mode:
[USB Mass Storage Device] or [Matshita DVC USB
Device]
• Make sure Camcorder’s Card Access lamp is off
and disconnect the cable.
• You can safely disconnect the cable.
3 Verify [Matshita DVC USB Device] is
selected and click [OK].
2 Select [USB Mass Storage Device] and
click [Stop].
CAUTION:
If you disconnect the USB Cable while the
Card Access Lamp is on, it may damage the
Card data.
Even when the following operations are performed,
the same results will occur as when the USB Cable is
removed (above). Therefore, it is imperative that the
above operation
1
is completed before proceeding.
• When Camcorder power is turned OFF.
• When SD Memory Card is removed.
• When Mode Dial is turned to change modes.
Removing the USB Cable safely for
Macintosh
1
Drop the [NO_NAME] icon which appeared
when you connected the Camcorder with
the USB Cable into the recycle bin, then
disconnect the USB Cable.
For Macintosh
If the above operation is not performed correctly,
when data is copied from the personal computer
to an SD Memory Card, the copied data may be
damaged.