Filter
Top Products
14
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfo
Before Using
3 Close the Cassette Holder by pressing the
[PUSH] mark
1
.
4 Only after the Cassette Holder is completely
housed, close the Cassette Compartment
Cover by pressing the mark
2
.
1
2
• When inserting a cassette, orient it as shown in
the above, and then securely insert it as far as it
goes.
When the Cassette Holder does not
come out
• Close the Cassette Compartment Cover
completely, and then open it again completely.
• Check if the battery has run down.
• Check if the Cassette Compartment Cover is in
contact with grip belt as shown below. If so, be
sure the grip belt stays clear of the cover when
opening.
When the Cassette Holder cannot be
housed
• Set the [OFF/ON] Switch
26
to [OFF], then to
[ON] again.
• Check if the battery has run down.
Accidental Erasure Prevention
• For other notes concerning this item, see page 52.
1
Opening the accidental erasure prevention slider
1
on the cassette (by sliding it to the [SAVE] arrow
direction) prevents recording. To enable recording,
close the accidental erasure prevention slider (by
sliding it to the [REC] arrow direction).
1 Open the LCD Monitor and then slide the
[◄OPEN] Lever
6
to open the Card Slot
Cover
7
.
Inserting a Card
6
7
Using a Memory Card (Optional)
A Card can be used to record still pictures.
• Use a genuine SD Memory Card or MultiMediaCard
manufactured by Panasonic only.
Before inserting or removing a Card, be sure to
turn off the Camcorder.
• Otherwise, the Camcorder may not function properly
or it may cause the loss of recorded data in a Card.
2 While holding the Memory Card with its cut
corner facing right
1
, insert it into the Card
Slot
8
.
1
8
3 Close the Card Slot Cover
7
securely.
Removing the Card
Open the Card Slot Cover and press the center of
the Card and then pull it straight out.
• After removing the Card, close the Card Slot
Cover.
• The Camcorder may be damaged if the Card is
forced out when the Card is fully inserted.
Concerning the Card
• Do not touch the terminals on the back of the
card.
• Do not format the card with another Camcorder or
any personal computer. This operation may make
the card unusable.
• Electrical noise, static electricity, or failure of the
Camcorder or the card may damage or erase the
data stored on the card. We recommend saving
important data on a personal computer by using
a USB Cable, PC Card Adaptor, or USB Reader/
Writer.
SD Memory Card
• The memory capacity indicated on the SD
Memory Card label corresponds to the total
amount of capacity to protect and manage
the copyright and the capacity available as
conventional memory for a Camcorder, personal
computer or other equipment.