Filter
Top Products
17
6. Secure the camera unit to the bracket
with the camera lock screw.
Camera fixing screw
7. Adjust the camera. (Refer to p. 20.)
8. Attach the enclosure to the camera.
Firmly tighten the three tamper-proof
screws.
(Recommended tightening torque:
0.78 N·m)
Notes:
• Defocus may be caused by the reinstalled enclosure. When using a system controller,
adjust the back-focus on the setup menu after attaching the enclosure.
• When not using a system controller, back-focus adjustment is available by using the
[ABF2] button after attaching the enclosure.
q Press the [ABF2] button. The LED indicator will start blinking.
w While the LED indicator is blinking (for around 3 minutes), attach the enclosure to the
camera.
e When the LED indicator changes to steady light, back-focus will be adjusted automati-
cally.
r After the back-focus is adjusted, the LED indicator will go out.
• Do not aim the camera to objects continuously moving.
• If the LED indicator blinks again after changing to steady light, back-focus adjustment
may have failed. In this case, check the back-focus on the LCD monitor. To adjust the
back-focus again, perform Step q to e again.