Filter
Top Products
41
18-2. Aperture Gain Setting (AP GAIN)
Move the "I" cursor to adjust the aperture gain level.
Lower the level when moire (a kind of noise, optical interference) appears on the screen as part
of minute crosshatch pattern, etc.
18-3. Pedestal Level Setting (PEDESTAL)
Move the "I" cursor to adjust the pedestal level (black level).
18-4. Pixel Compensation Setting (PIX OFF)
Perform settings to compensate a maximum of 16 blemish pixels on the pickup device.
1. Select PIX OFF and press the [SET] button.
→ The PIX OFF menu opens with numbers
from 1 to 16.
2. Select a number and press the [SET] button.
→ The PIX OFF assignment screen opens
with a + cursor.
3. Move the cursor to the centre of a blemish
position until its appearance becomes less
obvious. Finally, press the [SET] button.
→ The horizontal and vertical positions (coor-
dinate) of the blemish will be displayed
with a 6-digit number on the second bot-
tom line.
→ The blemish position is registered to be
compensated.
→ The screen returns to the PIX OFF menu
that displays the number followed by an
asterisk if it has been registered.
4. Repeat above steps as necessary.
5. To cancel a registration, select an asterisked number in the PIX OFF menu and press the
[SET] button.
→ The PIX OFF assignment screen opens.
Hold down the the [LEFT] and [RIGHT] buttons simultaneously for 2 seconds or more.
→ The PIX OFF menu appears displaying the number without an asterisk if its registration
has been cancelled.
**PIX OFF**
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16
000 000
RET TOP END