Filter
Top Products
Privacy zone
[Display type]
Select a display type of the privacy zone from the following.
• Gray: The privacy zones will be displayed in gray.
• Mosaic: The privacy zones will be displayed with a mosaic effect.
SW396
SW396
SW395
SW395
SC386
SC386
SC385
SC385
• Off: Does not display the privacy zones.
• Default: Off
Zone setting
[Zone select]
Click [
] of “Zone No” and select a zone number (1-8) (1, 2
SC384
SC384
SW175
SW175
SW174W
SW174W
SW172
SW172
ST165
ST165
ST162
ST162
) from the pull-down menu.
An asterisk (*) next to the zone number indicates that the privacy zone has already been set for the number.
A blinking mask will be displayed at the center of the image displayed on the [Image/Position] tab.
Operate the camera with the panning/tilting/zooming operations to cover the area to be covered by the blinking
mask.
Click the [Set] button after determining the position of the camera.
To delete the registered zone, click the [Delete] button after designating the desired zone number to be deleted.
Click the [Cancel] button to cancel the application or to delete the setting.
Note
• Set the privacy zone larger than the size of an object to be hidden.
To raise the precision of the privacy zone placement especially when the zoom is on the “Wide” side,
it is recommended to set the privacy zone with the zoom range between 1x and 3x.
• Panning, tilting and zooming operations can also be carried out on the [Image/Position] tab.
• When selecting “Zone No” after selecting “Gray” for “Display type”, a mask will be displayed at the
center of the image display area and will start blinking while changing its color as follows: Dark gray
® Clear ® Light gray
• When the other mask that had already been set is on the same zone, the mask that had previously
been set will blink as follows: Dark gray ® Light gray
• When selecting “Zone No” after selecting “Mosaic” for “Display type”, a mask will be displayed at the
center of the image display area with a mosaic effect.
When the other mask that had already been set is on the same zone, the mask that had previously
been set will be displayed in dark gray.
SW396
SW396
SW395
SW395
SC386
SC386
SC385
SC385
[Zoom] buttons, [Focus] buttons
SW396
SW396
SW395
SW395
SC386
SC386
SC385
SC385
SC384
SC384
, [Brightness]
buttons, Control pad/buttons and [Go] button
Refer to page 12 for descriptions of how to operate these buttons/pad.
[Close] button
Click this button to close the “Privacy zone” setup menu.
128 Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]