Filter
Top Products
5 Transmit images onto an FTP server
Images can be transmitted to an FTP server. By configuring the following settings, transmission of images
captured at an alarm occurrence or captured at a designated interval to an FTP server will become available.
IMPORTANT
• When using this function, set the user name and the password to access the FTP server to restrict
users who can log into the FTP server.
SW396
SW396
SW395
SW395
SC386
SC386
SC385
SC385
SC384
SC384
SW175
SW175
SW172
SW172
ST165
ST165
ST162
ST162
:
• To transmit images to the FTP server, select “Not use” for “SD memory card”, or when “JPEG” is
selected for “Recording format”, select “FTP error” for “Save trigger” on the [SD memory card] tab of
the “Basic” page. (®page 59)
5.1 Transmit an alarm image at an alarm occurrence
(Alarm image transmission)
An alarm image can be transmitted at an alarm occurrence to the FTP server. To transmit alarm images to an
FTP server, it is necessary to configure the settings in advance.
The settings for the FTP server can be configured on the [FTP] tab of the “Server” page. (®page 162)
The alarm image transmission function can be turned on/off in the “Alarm image” section of the [Alarm] tab of
the “Alarm” page. (®page 138)
Note
• Depending on the network line speed or the network traffic, the number of the transmitted images may
not reach the set number of images to be transmitted.
SW396
SW396
SW395
SW395
SC386
SC386
SC385
SC385
SC384
SC384
SW175
SW175
SW172
SW172
ST165
ST165
ST162
ST162
:
• Alarm images that failed to transmit to the FTP server at an alarm occurrence will not be saved on the
SD memory card. However, images that failed to transmit to the FTP server using the FTP periodic
image transmission function will be saved.
5.2 Transmit images at a designated interval or
period (FTP periodic image transmission)
Images can be transmitted at a designated interval or period. To transmit images at a designated interval or
period, it is necessary to configure the settings in advance.
The settings for the FTP server can be configured on the [FTP] tab of the “Server” page. (®page 162)
It is possible to determine whether or not to use the FTP periodic image transmission function and to configure
the settings relating to alarm images and the schedule on the [FTP img. trans.] tab of the “Network” page.
(®page 197)
Note
• Depending on the line speed or the traffic, images may not be transmitted at the designated interval.
• When “On” is selected for both the alarm image transmission function and the FTP periodic image
transmission function, the alarm image transmission function will be given priority over the FTP periodic
image transmission function. Therefore, images may not be transmitted at the interval designated on
the “FTP periodic image transmission” setting.
Operating Instructions 35
5 Transmit images onto an FTP server