Filter
Top Products
10 C2910M-A (4/05)
Camera Mounting
The CCC5100H Series camera can be mounted from either the top or bottom, depending on the type of camera mount used in your installation.
Use a standard 1/4-20 screw (provided) with a maximum thread length of 0.375 inch (10 mm).
The optional Pelco PCM150 camera mount is designed specifically for CCC5100H Series cameras. It can be used to wire and mount both high and
low voltage models quickly. (Refer to
Multifunction Connector
as well as the PCM150 documentation for more information about using the
PCM150 camera mount.)
Figure 4.
CCC5100H Series Camera and PCM150 Mount
The CCC5100H Series camera can be fitted with most Pelco lenses and mounted into most Pelco domes and enclosures, resulting in the greatest
possible number of combinations. This means you can find a solution for nearly any application.
When selecting a lens, dome, or enclosure for this camera, consider how the physical dimensions of each component may affect camera instal-
lation
and
operation. Specifically, you should address the following three issues.
•
Enclosure size:
The camera dimensions are 3.60 (L) x 2.77 (W) x 2.4 (H) inches (9.14 x 7.03 x 6.09 cm). Make sure the enclosure is large
enough for both the camera and the lens.
•
Lens size:
Some lenses have minimum and maximum lengths. To focus the scene correctly, you may have to adjust the lens to its maximum
length. This could affect how it fits within the enclosure.
•
Optical alignment:
The optical center of this camera may be too low for some enclosures. As a result, the lower portion of the scene may
be obstructed by the enclosure itself. The camera sled in many Pelco enclosures has a low side and a high side. You may be able to raise
the optical center by simply flipping the camera sled to the high side.
WARNING:
The maximum thread depth is 0.4 inch (1 cm). Do
not
use a longer screw or you may damage the camera.
NOTE:
To simplify lens and enclosure selection, Pelco offers ImagePak
®
options for the CCC5100H Series camera. Select the lens and the
dome or enclosure. Pelco will build and test it for you. Contact Pelco or your dealer for more information.