Filter
Top Products
12 C2950M-E (8/10)
SERVICE CABLE
The camera includes a service port that outputs camera video. Use it at the installation site to set up the field of view and to focus the camera.
Pelco offers an optional service cable (IX-SC) that connects directly to the service port. The service cable has a male BNC output for most
standard viewers.
NOTE: The ICS-SC and CST150 are not compatible with this camera. If you have any questions about service cable compatibility, contact
Pelco Product Support at 1-800-289-9100 (USA and Canada) or +1-559-292-1981 (international).
To assemble a service cable for the camera, purchase the following items from an electronics supply store:
To assemble the cable:
1. Attach the CPM 88 miniature coaxial connector to one end of the cable. Follow the directions supplied with the miniature coaxial connector.
2. Attach the 2.5 mm stereo plug to the other end of the coaxial cable (refer to the figure below):
a. Remove the support sleeve from the plug.
b. Slip the shrink fit tubing and support sleeve over the end of the cable.
c. Prepare the cable:
(1) Strip back the outer jacket 0.318 inch (8.06 mm) inch from the end of the cable.
(2) Pull back the coaxial braid shield.
(3) Strip back the insulating material 0.125 inch (3.18 mm) inch to expose the center conductor.
d. Solder the center connector of the cable to the shoulder pin of the plug.
e. Heat the shrink fit tubing around the center conductor and shoulder pin
f. Pull the coaxial braid shield back through the crimp pin and solder it to the top of the crimp pin arm.
g. Crimp the end of the crimp pin around the cable.
h. Reassemble the support sleeve and the plug.
Figure 6. Attaching the 2.5 mm Stereo Headphone Plug
Qty Description
1 2.5 mm stereo plug (male)
1 CPM 88 miniature coaxial connector
1 RG174/U coaxial cable
1 1/8-inch shrink fit tubing, 1/2-inch long
ì
2.5 mm Stereo Plug
ó
Shrink Fit Tubing
î
Plug Shoulder Pin
r
Coaxial Cable
ï
Center Conductor
s
Coaxial Braid Shield
ñ
Support Sleeve
t
Crimp Pin Arm