Filter
Top Products
C2950M-E (8/10) 39
SELECTING MANUAL EXPOSURE SETTINGS
Figure 23. Manual Exposure Page
1. Place your mouse pointer over the Imaging tab.
2. Select Exposure from the drop-down menu.
3. Select the Manual mode.
4. Move the Analog Gain slider to the desired position. Increasing the gain increases the brightness of the image, but it also increases the
amount of noise in the image. The analog gain range is 1.00 to 15.75; the default setting is 1.00.
5. Move the Exposure Time slider to the desired position. This setting is the maximum time in milliseconds that the sensor is exposed to the
light. Decreasing the maximum exposure time decreases the light sensitivity. The exposure time range is 0.01 to 1000 msec; the default
setting is 15 msec.
6. Day/night cameras only: Set the Day Night Position setting.
Day: Sets the IR filter to the Day (color) position.
Night: Sets the IR filter to the Night (black-white) position.
Refer to the following section for more information:
• Day Night Settings on page 40