Filter
Top Products
12 C311M-O (11/07)
TXB Series Translator Board Installation (Optional)
Pelco’s TXB Series allows controllers from other companies to communicate with the Esprit system.
To install a TXB Series board, remove the left cover of the pan/tilt. Once the cover is removed, refer to the manual supplied with the translator
board to complete the installation.
HOW TO REMOVE THE PAN/TILT COVER
1. Unscrew the Phillips screw located on the left cover of the pan/tilt.
2. Remove cover and place to the side.
HOW TO REINSTALL THE PAN/TILT COVER
The pan/tilt covers must be properly seated and have a tight seal (all the way around) when installed.
PLUG
PHILLIPS
SCREW
NOT SEALED
THIS SIDE IS
IMPROPERLY
INSTALLED
GAP
THIS SIDE IS
PROPERLY
INSTALLED