Filter
Top Products
C311M-O (11/07) 63
ZOOM
Zoom programs the horizontal display position of the Zoom label. The following settings are available for the Zoom label:
• Off: Label is not displayed.
• Left: Label is displayed on the left-hand side of the screen.
• Center (default): Label is displayed in the center of the screen.
• Right: Label is displayed on the right-hand side of the screen.
NOTE: Zoom display is not available while you are programming or running a pattern.
To program the horizontal label position for Zoom:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Other.
3. Press the Iris Open button to enter the Other menu.
4. Position the cursor (>) beside Az/El/Direction.
5. Press the Iris Open button to enter the Az/El/Direction menu.
6. Position the cursor (>) beside Zoom.
7. Press the Iris Open button. The cursor moves to the right.
8. Move the joystick up or down to view the available selections.
• Iris Open: Press the Iris Open button to select your choice.
• Iris Close: Press the Iris Close button if you do not want to change the setting.
Proportional pan On
Park time minutes 0
Scan Speed deg/s 25
Pattern Length 1.5 min
Spd Profile
<Zone Blank>
<Az/El/Direction>
Exit
Other Menu
Set Azimuth Zero
Az/El
Az/El Line
Direction
Direction Line
Zoom
Zoom Line
Disp Duration
Exit
Az/El/Direction
MAIN MENU
<Camera>
<Line Sync>
<Power Up Mode>
<Wiper>
<Limit Stops>
<Text Display>
<Alert>
<Other>
ACK Alert
Exit