Filter
Top Products
8 C311M-O (11/07)
Installation
1. When installing the ES30PC/ES31PC Esprit system, allow for sufficient clearance between the top of the unit and overhead obstructions.
This will prevent interference when the enclosure is driven to its maximum elevation of 33 degrees.
2. Remove the transformer module from the base of the system by
loosening the four Phillips screws and lifting the module.
3. Attach the base of the system to an Esprit mount (EWM or EPP):
a. Apply a drop of Loctite
®
thread compound (supplied) to
each of the three mounting holes and 10-32 x 1/2-inch
flathead screws (supplied).
WARNING: Applying the Loctite thread compound is an important
step in the installation process. Failure to apply Loctite to the
mounting holes may increase the risk of damage to the unit.
b. Attach the base of the system to the mount using the three
screws and washers.
MODEL ES30 ES31
A
16.6
(42.5)
16.9
(42.9)
B
9.4
(23.9)
9.7
(24.6)
C
7.1
(18.1)
7.6
(19.2)
D
4.2
(10.7)
4.6
(11.7)
A
33.0°
B
CD
NOTE: VALUES IN PARENTHESES ARE CENTIMETERS;
ALL OTHERS ARE INCHES.
BASE
LOOSEN
PHILLIPS
SCREWS
TRANSFORMER
MODULE
MOUNT
MOUNTING HOLES
BASE
MOUNTING
SCREWS