Filter
Top Products
52 LDK 8000 HDTV camera system User’s Guide (v3.0)
Chapter 5 - Operating instructions
5.7 Video preferences
The means used to control the camera depends on your work methods. A remote OCP can be
used and a low user level can be selected to restrict the available camera functions.
Alternatively, video functions can be controlled on the camera itself. The following functions
are available on the camera:
• Standard settings
• Test signal
• Gain selection
• Optical filter selection
• Colour temperature
• Auto-white balance
• Exposure time
• Black stretch
• Auto skin detail
Many other video functions such as detail, black, gain, knee, gamma, matrix and white limit
functions are available in the VIDEO menu.
5.7.1 Standard settings
To ensure that some of the camera functions are not set to unusual values, a standard file has
been defined that contains the default values for most video functions. The table in the
Appendix lists the values that are set when the standard file is recalled.
To recall the standard values for the various video functions, press the green STD button on
the left-front side of the camera and hold it for two seconds. The standard values only take
effect when the camera is not on-air.
The standard file can be selected as either a factory or a customer standard file. Changing the
standard file can only be done in the System security menu if the owner card or the PIN code
is used.
The Non-standard indicator lights when the video settings are not set to their standard value,
for example, when exposure is not set to nominal. It also lights when black stretch or extended
auto iris is on and if AWC, FL50 or FL60 is selected with the colour temperature selector.