Filter
Top Products
LDK 8000 HDTV camera system User’s Guide (v3.0) 57
Chapter 5 - Operating instructions
☞
Note
If you did not select one of the memory positions FL50, FL60, AW1 or AW2, the ’Precondition
fail’ message appears in the viewfinder.
3. Point the camera so that the reference white surface is between the two small white
boxes.
4. Press the White balance switch again to start the measurement procedure. A message
indicating that the process is runnning appears.
☞
Note
If there is insufficient light, the ’Light level too low’ message appears in the viewfinder.
5. When the process is completed (within a few seconds) the OK message and the
measured temperature appear in the viewfinder.
The measured colour temperature is now stored in the selected memory position and can be
recalled as required.
☞
Note
During the auto-white measurement process iris is set to Auto and 90% and the knee is turned
off.
Black balance is not necessary with this camera because of the continuous automatic black
control circuits.
ND/RE
BATT
MEDIA
REC
++
+
-
AW2AW1
FL
7.55.63.2
FOC+
4.7
!
AWHITE: running
ND/RE
BATT
MEDIA
REC
++
+
-
AW2AW1
FL
7.55.63.2
FOC+
4.7
!
AWHITE: OK 3700K