Filter
Top Products
First-Time Operation
13
Caution: When a battery is attached to the adapter/charger, do not turn them
upside down. The battery may fall off and be damaged or cause injury.
Charge the Battery
If the DC cable is attached to the DC
OUT jack on the adapter/charger, remove
its plug.
1. Plug adapter/charger into nearest AC
outlet (100-240V, 50/60Hz). The
POWER indicator lights.
2. Align reference marks on battery with
marks on adapter/charger, and slide the
battery in the direction of the arrow
until it locks into place.
3. If the battery is properly connected,
the adapter/charger’s CHARGE
indicator will light.
Note: The CHARGE indicator will flash
rapidly if the battery is not installed
properly. Remove the battery from the
adapter/charger and attach it again. If the
indicator still flashes, the battery cannot be
charged.
4. When the CHARGE indicator turns
off, remove the charged battery by
sliding it off the adapter/charger.
5. Remove the power cord from the
AC outlet.
Refresh the Battery
The battery will provide increased
operation time if you “refresh” it before
every charging. The refresh feature
“refreshes” the battery by completely
discharging it. Refreshing takes
approximately 4 hours.
1. Plug in the adapter/charger and
attach the battery.
2. Press REFRESH. The CHARGE
indicator flashes slowly while the
battery discharges.
3. When discharging is completed, the
CHARGE indicator stops flashing.
Then the battery begins charging.
4. After the battery is charged, the
CHARGE indicator turn off.
Hold Battery
Flush and
Slide
To AC Wall
Outlet 100-
240 Volts,
50/60 Hz.
CHARGE
Indictor
POWER
Indicator
Adapter/Charger
REFRESH
Button
Reference Marks