Filter
Top Products
52
Trouble Checks
• Displays will be recorded on tape whenever they
appear in the viewfinder. Remove them from
viewfinder when recording. See page 33.
• When AUTO DATE is selected, the date will
automatically be recorded when you begin recording
or change the cassette. See page 33.
• Clock lithium cell battery may need replacing.
See page 31.
• Date or time may need to be set. See page 32.
• This may occur when background extremely
contrasts with the subject.
• If battery has not been used for some time,
completely drain the battery’s power and then
recharge it.
• Battery run times are measured when the camcorder
is recording continuously. You can check your
battery by first fully charging it and then aiming the
camcorder at a clock and recording the picture of the
clock. When the recording stops, play the last
recorded section and note the clock time. A one-hour
battery should give you about 50 minutes of
recording time using the LCD monitor. In practical
use, you may not be able to record for the full time
because the camera uses battery power when it is
waiting between recordings (record-pause) and
zooming.
Trouble Checks and Adjustments
Date and/or time were
recorded on tape
Date and/or time are
incorrect
Vertical white lines
appear when shooting
bright object
Rechargeable battery
runs down sooner
than expected