Filter
Top Products
7
Inserting and Removing
the Battery Pack
Inserting the Battery Pack
1 Slide the battery compartment door release
on the bottom of the Camcorder in the
direction of arrow (1), to open the battery
compartment door (2).
2 Insert the battery pack into the compart-
ment and push it in completely.
3 Close the door. Be sure to push firmly in
the center of the door until it clicks.
Removing the Battery Pack
1 Perform step 1 in the above procedure.
2 With the Camcorder facing down, press the
lock as shown, and remove the battery
pack.
Battery Pack Handling
• Make sure that you take enough battery packs
with you to provide two to three times your
estimated recording time.
• Recording time will be reduced in cold weather.
• The battery will drain in Recording Standby
mode. Turn off the power if you will not be
recording again soon.
Cautions
• ALWAYS STOP THE TAPE AND TURN THE
POWER OFF, BEFORE REMOVING THE
BATTERY PACK. If you remove the battery
pack during recording or playback, the tape will
remain wound around the video head drum and
may be damaged. Should the power source
(battery or adapter) become disconnected
during operation, reconnect it again immedi-
ately.
• Do not expose the battery compartment door to
strong force, as it may come off.
• Be sure to close the battery compartment door
firmly, especially before using the Camcorder. If
you do not, the battery pack may come out or
Camcorder operation may fail because of the
poor contact pressure.
• Remove the battery pack from the Camcorder
or disconnect the Camcorder from the AC
adapter if the Camcorder will not be used for a
long time.
• When removing the battery pack, do not tilt the
Camcorder so that the battery compartment
faces down. The battery pack may fall out.
1
2
Battery
compartment
door release
Lock
Cadmium batteries thoughout the United
States. Please call 1-800-8-BATTERY for
informtion or contact your local recycling
center.
RBRC
RBRC
Ni-Cd
ATTENTION: The RBRC
seal on the battery used in
your Thomson Consumer
Electronics product indicates
that we are participating in a
program to collect and
recycle Nickel
Powering the Camcorder
Preparation
p01~10 4/8/97, 10:08 AM7