RCA ProV712 Camcorder User Manual


 
21
Optional Accessories
Optional Accessories
We invite you to take a look at some great ideas for
sparking creativity and adding to the fun of using
your Camcorder. These accessories are designed to
make the process of recording and watching your
videos more enjoyable.
To order accessories, contact your local Dealer. If a
dealer is not nearby, all accessories are available
through toll-free ordering or by using the order form
on page 23.
BB45 and BB50 Battery Packs
These rechargeable batteries are designed
specifically for long life. The BB45 is the same
battery that came packed with your camcorder. The
BB50 is an extended battery pack. Both can be
recharged with the adapter/charger that came with
your Camcorder.
SUN102 Sun Hood
This sun hood helps protect the lens from strong
sunlight when recording on a bright sunny day.
SDC100 Car Battery Adapter
This car battery adapter enables you to operate
your Camcorder from your car, truck, or RV by
plugging the car cord directly into the vehicle’s
cigarette lighter socket. The SDC100 is designed
specifically to convert power from only a 12-volt or a
24-volt negative ground car battery to a 4.5-volt
output.
Caution: Do not use any other car battery
adapter with with Camcorder.
Using the Optional AC088 Tripod
Mounting the Camcorder on a tripod, such as
AC088, will keep the camcorder steady and
produce excellent video results.
This tripod’s fluid-effect head provides smooth
camera pan and tilt. The quick-release mount
makes it easy to attach or remove the Camcorder.
The grooved, tubular 3-section leg design folds
down to 26 inches when not in use. Rubber feet
allow for sure footing.
Cautions: Before using a tripod, make sure it is
stable enough to hold the Camcoder without falling
over. Do not transport the Camcorder attached to
the tripod.
When attaching your Camcorder to a tripod, be
careful not to force the tripod screw into the
Camcorder’s tripod mounting hold.
The tripod screw should not protrude into the
camcorder more than approximately three-eighth
(3/8) inch. Forcing the screw could damage the
mounting hole on the bottom of the camcorder.
BB45 BB50
Connections
References
p11~33 4/8/97, 10:09 AM21