RCA ProV712 Camcorder User Manual


 
ii
This Camcorder does not have a PCM recording or playback function. PCM recordings
made using other VCRs or audio dubbing cannot be played back on this unit.
If you record on a tape on which PCM sound has already been recorded, the audio
track of the new Camcorder recording may not come out if the tape is played back on
a PCM-capable VCR. If this occurs, set the VCR’s audio monitor select switch to the
“STANDARD” position.
Your Camcorder is designed to record in SP mode only. It will not perform normal
playback for programs prerecorded in LP mode.
INFORMATION
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-
ing two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
WARNING—FCC Regulations state that any unauthorized changes or modifica-
tions to this equipment not expressly approved by the manufacturer could void the
user’s authority to operate this equipment.
NOTE
The Camcorder’s LCD panel is a very high technology product with close to 90,000
(ProV712)/more than 112,000 (ProV714) thin-film transistors*, giving you fine picture
detail. Occasionally, a pixel may appear on the screen as a fixed point of blue, green,
red, or black. Please note that this does not affect your Camcorder’s performance.
*Specifications are subject to change without notice.
Important Information
caution 4/8/97, 10:07 AM2