Filter
Top Products
<<
43
>>
Metering Drive mode
If you cannot obtain suitable exposure conditions, you can change the
metering method to take brighter pictures.
[Multi] : Exposure will be calculated based
on an average of the available light
in the image area. However, the
calculation will be biased towards
the centre of the image area. This is
suitable for general use.
[Spot] : Only the rectangular area in the
centre of the LCD monitor will be metered for light.
This is suitable when the subject in the centre is exposed
correctly, regardless of the back lighting.
If the subject is not the centre of the focus area, do not use the
spot metering as this may result in an exposure error. In this
circumstance, it is better to use exposure compensation.
METERING
Multi
[Single] : Take one picture only.
[Wise Shot] : Two images are taken at a
time. One is taken in the Fill-
In Flash mode and the other
is taken in the ASR mode.
[Continuous] : Images will be taken continuously until the shutter
button is released.
[AEB] : Take three pictures in a series in different exposures:
standard exposure (0.0EV), short exposure (-1/3EV)
and over exposure (+1/3EV).
[Motion Capture] :
This takes 6 shots per second, and for max 5 seconds,
when the shutter is pressed and held down. The
maximum number of shots is 30 and the image size is
fixed as VGA.
You can select continuous shot, and AEB (Auto Exposure Bracketing).
DRIVE
Single
High resolution and picture quality increases file saving time, which
increases stand-by time.
If the [Continuous], [AEB] or [Motion Capture] sub menu is selected,
the flash will be off automatically.
If less than 3 pictures are available in the memory, the AEB shooting
is not available.
It is best to use a tripod for the AEB shooting as the time to save each
image file is longer and blurring caused by camera shake may occur.
If less than 30 pictures are availabe in the memory, the Motion
Capture shooting is not available.