Samsung U-CA 3 Digital Camera User Manual


 
40
Metering
If you cannot obtain suitable exposure conditions, you can change the metering method to take
brighter pictures. This can be set in Auto and Manual modes.
MULTI( ) : Exposure will be calculated based on an
average of the available light in the
image area. However, the calculation
will be biased towards the centre of the
image area. This is suitable for general
use.
SPOT( ) : Only the rectangular area in the center
of the LCD monitor will be metered for
light. This is suitable when the subject in the center is exposed correctly,
regardless of the back lighting.
The default metering mode is Multi pattern metering.
If the subject is not the centre of the focus area, do not use the spot metering as this may
result in an exposure error. In this circumstance, rather use exposure compensation.
INFORMATION
Effect
By using the camera’s digital processor, it is possible to add special effects to your images.
You can select from AUTO, MANUAL, and Movie Clip modes. The value you set will remain
unchanged until the camera is turned off.
NORMAL: No effect is added to the image.
B & W : Converts the image to black and white.
SUNSET : Used for capturing images at sunset
SEPIA :
Captured images will be stored in a sepia tone (a gradient of yellowish brown colours).
RGB : Allows the user to adjust the R (Red), G (Green), and B (Blue) values of the images
to be captured.
MULTI
SPOT
METERING
[ STILL IMAGE mode ]
NORMAL
B & W
SUNSET
SEPIA
EFFECT
[ MOVIE CLIP mode ]
NORMAL
B & W
SUNSET
SEPIA
EFFECT