Samsung SHR-5082 Security Camera User Manual


 
CancelOK9-16
PTZ Device
Cam ID Protocol Baudrate Parity Data Stop
1 000n Samsung 38400 None 8 1
2 001 Vic. 38400 None 8 1
3 002 Pan. 19200 None 8 1
4 003 Dia. 38400 Even 8 1
5 004 None 38400 None 8 1
6 005 None 38400 None 8 1
7 006 None 38400 None 8 1
8 007 None 38400 None 8 1
Half Duplex
Serial Mode :
ExitDefault
Brightness
050
Contrast 050
Color 050
CancelOK
Monitoring
Event Monitoring Duration Off
OSG Display Date On
Time On
Title On
Status On
Spot Out Channel CH1
Spot Out Event Monitor Off
Monitor Out Dual OUT
PB Channel Position Right Down
Multi Channel Seq. 5sec
26_ menu setup
PTZ Device
You can configure the PTZ device related
settings.
ID
ID for PTZ camera. It can have any number
among 0 to 255.
Protocol
Protocol that is supported by the PTZ device.
Available protocols are Samsung, Vic., Pan.,
A
D, Phi., Ern., Pel-D, Pel-P, Vcl., Dia., Kal., and
Tech.
Baudrate
Available baud rates are 600, 1200, 2400,
4800, 9600, 19200, and 38400.
Parity
Select one of None, Even, and Odd.
Data
Select 7 or 8 for data bit.
Stop
Select 1 or 2 for stop bit.
Serial Mode
Select Half Duplex or Full Duplex for data
exchanging method.
In case of SHR-5082, only 8 channels are
displayed.
CAUTION
The above setting values must be the
same as the ones of the PTZ device.
For more details, please refer to the
user manual for the PTZ device.
Screen Setup
It is used to set the brightness, contrast, and
color for the camera image of each channel.
Place the cursor on the channel that you want to
set the values for brightness, contrast, and color.
When a channel is selected, its image appears
on the right. For selection, press the ENTER
button. Use the UP/DOWN direction buttons to
change the value from 0 to 100.
When Default is selected, the value 50 is to be
assigned for each item of the selected channel.
In case of SHR-5082, only 8 channels are
displayed.
MONITORING
You can configure the monitoring-related
settings.
Event Monitoring
You can select any of Off, 3sec, 5sec, 10sec,
20sec, 30sec, and Continuous.
-
Off: Event monitoring does not work.
- 3sec, 5sec, 10sec, 20sec, and 30sec:
Sets the screen duration period in the Auto
Sequence (or auto sequence) mode.
-
Continuous: The event monitoring screen
remains alive until you press the ALARM
button.
SHR-5162_Eng.indb 26 2007-06-18 ソタタ・11:48:22